CS710 Axalta Percotop 2K Fast Activator 1L

FAQs

• Firstly measure out 2% of the supplied hardener onto a mixing board, fold the hardener into the filler until a uniform colour is achieved. Try to to introduce air to the mix as this will cause pinholes

• Yes. The putty is formulated for exceptional ease of sanding, allowing for a smooth finish with minimal effort — even on large areas

• Yes, it can be applied to bare steel and aluminum, provided the surface is properly matted and degreased. For optimal adhesion and corrosion resistance, ensure thorough surface preparation.

• The filler has resin on top when I open the tin what should I do?

  This product uses advanced lightweight glass beads that reduce overall density, making it ideal for large surface repairs without adding unnecessary weight to the vehicle.

• The primer can be applied using a spray gun with a nozzle size of 1.7–2.0 mm. Apply 2–3 coats, allowing appropriate flash-off time between layers. Ensure good ventilation and follow safety precautions during application.

• What is the recommended application method?

  The primer should be mixed in a 5:1 ratio with the dedicated hardener. For example, 5 parts primer to 1 part hardener by volume. Always follow the manufacturer’s guidelines for best results

• Visual check: Look for a uniform matte finish. Touch Test. Surface should feel dry and firm, not tacky

• Under standard conditions (20°C), the primer typically cures in 20–30 minutes before it can be sanded. Drying time may vary depending on ambient temperature, humidity, and film thickness

• When working with any 2K products, it is recommended to use personal protection equipment such as Air Fed respirator, safety goggles and gloves to Protect the eyes and respiratory system.

• What PPE is recommended ?

  The primer should be mixed in a 4:1 ratio – four parts primer to one part hardener. This ensures optimal curing time, adhesion, and surface finish

• Simple , pour the excess resin away into your solvent waste. This is rejection not separation. Do not mix it in as you will introduce air to the filler and increase your chances of pinholes

• Yes , 10-15 minutes of short waves for the thickness of 150-250 µm. Do not exceed 60°C. Wait about 10 minutes before starting the heater drying.

• 5-10 minutes between coats then 10 minutes before baking at 60°C

• Yes, it adheres excellently to steel and aluminum, provided the surface is properly flatted and degreased. It also works well on zinc-coated steel, fiberglass, and previously painted surfaces in good condition.

• What's better Q1 yellow or Indasa MTE Neon

  The Indasa MTE Neon Masking Tape is the superior choice for automotive applications due to its exceptional adhesion, high-temperature resistance (up to 100ºC), UV protection, and waterproof performance. It’s specifically designed for demanding environments, ensuring clean, precise lines and reliable results, even in extreme conditions.

• How do I know the Epoxy primer is dry?

  The PPE needed to spray any 2K (2 pack) product including Epoxy is a good respirator, ideally air fed. safety glasses or goggles , gloves and overalls

• No, mixing technologies will only cause problems. always activate your paint using the information found on the Technical data sheet with the correct hardener stated on the same Technical data sheet.